11/09/09

Bad news: the distributor for RRS (front strut system) no longer sells them. Now that I put all the time and money into the notch kit I have to figure out what to do. Any ideas would be appreciated. I have to stay with a strut system because of the notched shock towers. Not sure if RRS is in financial trouble or what?

11/06/09

My opinion it turned out nice.

Should have lots of room now for the engine.

Put a little filler around the edge to get a really nice finished look.

10/30/09

Just about ready for primer.

All welded now grinding. Should turn out nice.

10/16/09

After doing a reverse template to get the best fit to cut down on grind time they are finally welded in.

Minor grinding to do.

This is a good photo to show the extra tower support that was welded in prior to the new engine .

9/4/09

Getting the fit right so the weld is good.

I am extremely slow at this stuff. The extra support on the bottom was difficult to deal with for fit.